| dc.identifier.citation | [1] Ryerson, McG.H., Dictionary of Scientific and Technical Terms, 6th ed., published by The McGraw-Hill Companies Inc, New York, 2003. [2] Bappenas, Pembangunan Daerah Tingkat 1, Bappenas, Daerah Istimewa Yogyakarta, 2013 [3] Pegden, D.C., Shannon, R.E., and Sadowski, R.P., Introduction to Simulation Using Siman, 2nd ed., McGraw-Hill, New York, 1995. [4] Soeharto, I., Studi Kelayakan Proyek Industri, Erlangga, Jakarta, 2002. | en_US |
| dc.description.abstract | Machining center is used to handle the
manufacturing of material feeding using computer numerical
control and a lot of various types of equipment and operation. It
is needed to improve the productivity rate and has been
developed in several countries. But, in Indonesia, there hasn’t
been much development of this technology. This paper present
the feasibility study of Machining Center on Small and
Enterprises (SMEs) in Yogyakarta. The study begins with
determining the technology map of SMEs in Yogyakarta, built
the simulation in ProModel, and calculated the economic
feasibility. The concept of Machining Center consists of six
processes and is integrated with computer. The result of
simulation indicate that the installation of machining center
could increase the production capacity that are 51% for A type,
88% for B type, and 91% C type. Based on the economic
feasibility analysis, the installation of machining center is feasible
to implement with PBP for 4.51 years, NPV of Rp 259.561.824,
and an IRR of 13%. | en_US |
