| dc.identifier.citation | Kumar, R.A. , Varghese, S. , Siva pragash, M., 2012, A Coparative Study Of The Mechanical Proper ties Of Single And Double Sided Friction Stir Welded Aluminium Joint, Procedia Engineering 38 ( 2012) , p, 3951 – 3961. Mishra , R.S. , Ma , Y.z, 2005, Friction Stir Welding And Processing Mater ia ls Science and Engineer ing, R 50: 1– 78. Nurdians yah, F. , Soewe if y, Zubaydi, A., 2012, Pengaruh Rpm Terhadap Kualitas Sambungan Dan Metalurgi Las Pada Joint Line Untuk Alluminium SerI 5083 Dengan Proses Friction Stir Welding, Jurnal Teknik ITS Vol. 1 (September 2012) p. G55 - G58. Raja kumar , S., Ba lasubra mania n, V. , 2012, Correlation between weld nugget grainsize , weld nugget hardness and tenlile strength of friction stir welded commercial grade aluminium alloy joints , Materials and Design 34: 242–251. Smallma n,R.E. ,B ishop, R.J., 2000, Metalurgi Fisik Modern Dan Rekayasa Material, Erlangga , Jakarta. Sudrajat, A. , 2012, ”Analisa Sifat Mekanik Hasil Pengelasan Aluminium AA 1100 Dengan Metode Friction Stir Welding ( FSW )”, Tugas A khir S -1, Teknik Mes in Universitas Jember, Jember. Wijayanto, W., 2015, “Pengaruh Sudut Kemiringan Tool Terhadap Sift Mekanik Dan Str uktur Mikro Sambungan Pelat Aa5083 Pada Proses Friction Stir Welding”, Tugas Akhir S- 1, Teknik Mesin Universitas Sebelas Maret, Surakarta. Wiryosumarto, H. , O kumura, T., 1994,Teknologi Pengelasan Logam, Cetakan Ke- 6, PT. Pradnya Paramita , Jakarta. | in_ID |
| dc.description.abstract | Friction stir welding (fsw) is a welding method that takes benefit of the hea t released by the friction of two metals. The objective of this work was to investigate the effect of depth plun ge on the ph ysical an d mecha nical properties of double sided friction stir welding.The experiment was carried ou t using vertical milling machine on the material of Al 508 3 with size of 200 x 100 x 3 mm. The ro tation al speed of sp indle wa s 12 50 rpm, the sp eed of feeding was 12,5 mm/mnt, and the pin depth variations were 0,9 mm, 1,9 mm and 2,9 mm. The results showed that the maxi mum tensile stress ob tained in the depth plunge of 1,9 mm was 177 ,78 MPa. The Vick ers test showed that the hardness of weld zone was lower than that of the base metal, but the lowest hardness was found in the HAZ. The joining area showed a good adhesion, but the void defect was obtained in the prod uct welded using a depth plunge of 2,9 mm. In the st ir zone, the grain size of the phase became smaller. | in_ID |
